The substrate

The substrate has to be prepared before microcement goes on, to avoid problems later. These are the most common substrates in construction. What goes on first depends on the substrate and the condition it is in.

Tradesman sanding the ceiling of a room under renovation
Concrete steps in raking light

Cement-based substrates

Check that the substrate is in good condition. It must hold 1.5 N/mm² in a pull-off test. If it does not, apply a concrete consolidator first. If there is moisture in the substrate, apply a moisture barrier: an epoxy primer against damp. Finish with two coats of microcement Base.

Applies to
  • Concrete slabs
  • Ready-mixed self-levelling screed
  • Bagged self-levelling screed
  • Other mortars

Preparation

  1. Compactecif the substrate is weak
  2. Moisture barrier and meshwhere there is a lot of moisture
  3. Base coat Microröck or Microflextwo coats

Microröck or Microflex? What is very hard is less elastic, and the other way round. Choose Microröck Base for a very strong, hard substrate. Choose Microflex Base for a more elastic one that resists cracking.

Underfloor heating pipes laid in loops on mesh

Underfloor heating

On heated floors, the base coat Microdur or Microflex is applied directly. Both conduct heat.

Applies to
  • Anhydrite self-levelling screed

Preparation

  1. Base coat Microdur or Microflex

Microne: Goes on floors with underfloor heating only in the Plus version, with hardener, according to the data sheet.

Room with newly fitted plasterboard

Plasterboard

The surface is very porous, so Primer TAC and mesh are needed.

Applies to
  • Standard plasterboard
  • Gypsum plaster

Preparation

  1. Primer TAC and mesh
  2. Base coat Microdur
White tiled wall with clear joints

Tiles

The joints have to be filled first, with a joint filler: an epoxy compound that fills and levels the joints.

Applies to
  • Unglazed tiles
  • Ceramic tiles
  • Porcelain tiles
  • Natural stone or limestone
  • Marble
  • Glass tiles
  • Encaustic cement tiles
  • Granite

Preparation

  1. Fill the joints
  2. Base coat Microröck or Microflex

Good to know

These recommendations give a good result when the project runs normally. The professional should still always assess the substrate and take a sample of it before work starts, and choose the solution from that. It prevents surprises that affect the microcement. We do not lay microcement on wood or MDF. They are living materials.

Where will the surface go?

Cemher is Zenzorama's microcement partner.

zenzorama.no